Sanus Systems VMAA26 User Manual

Assembly Instructions for Model: VMAA26

Thank you for choosing a Sanus Systems VisionMount™ wall mount. The VMAA26 is designed to mount up to 50” Flat panel televisions

weighing up to 130 lb. to a vertical wall. It allows you to tilt the television from +5° to -15°. It will also extend 25.75” away from the wall,

swivel up to 180°, and roll ± 6°.

CAUTION: The size and weight of your television must not exceed 50” [1270 mm] diagonally and 130 Lbs [59 Kg]. The wall

must be capable of supporting five times the weight of the television plus the wall mount. Never use defective parts. Improper

installation may cause property damage or personal injury. Do not use this product for any purpose that is not explicitly

specified by Sanus Systems.

If you do not understand these directions, or have any doubts about the safety of the installation, please call a qualified contractor

or contact Sanus at 800.359.5520 or www.sanus.com. Our customer service representatives can quickly assist you with installation

questions and missing or damaged parts. Replacement parts for products purchased through authorized dealers will be shipped directly

to you. Check carefully to make sure that there are no missing or defective parts. Sanus Systems can not be liable for damage or injury

caused by incorrect mounting, incorrect assembly, or incorrect use. Please call Sanus Systems before returning products to the point of

purchase.

NOTE: This mount is not intended for use on brick, concrete block, concrete, or steel wall studs. Typical wall anchors do not

have sufficient holding power to support this mount. It is up to the installer to verify the safety of any installation method or

hardware that is not provided by or recommended by Sanus Systems. Sanus Systems makes every effort to assure all necessary

television mounting hardware is included. If the television mounting hardware you need is not included please consult your

local hardware store or call Sanus Systems

Required Tools: 3/16” drill bit, drill, adjustable or crescent wrench, Phillips screwdriver.

Supplied Parts: (Some parts are not shown at same scale)

Wall Plate - A

Qty. 1

I” Diameter Tube - D

Qty. 2

Preventor - C

Qty. 1

Arm Assembly - B

Qty. 1

Vise Assembly - F

Qty. 4

Monitor Bracket - E

Qty. 2

Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 09.26.06 (6901-100017)

Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com