Sony MDR DS4000 Manual
Preparation
7
GB
Rear Panel of the Processor
ATT
LINE IN
DIGITAL
IN
L
0dB
-8dB
R
DC IN 9V
OUT
1
2
3
4
5
1
ATT (attenuator) switch
Set this switch to “0dB” if the volume is
too low at analogue input. Normally, this
switch should be set to “–8dB.”
too low at analogue input. Normally, this
switch should be set to “–8dB.”
2
LINE IN jacks
(see page 14 for details)
(see page 14 for details)
Connect the audio output jacks on audio
or video component (sold separately),
such as a video cassette player or TV, to
these jacks.
or video component (sold separately),
such as a video cassette player or TV, to
these jacks.
3
DIGITAL IN jack
(see page 13 for details)
(see page 13 for details)
Connect a DVD player, Digital
Broadcasting Satellite Receiver, or other
digital component (sold separately) to this
jack.
Broadcasting Satellite Receiver, or other
digital component (sold separately) to this
jack.
4
DIGITAL OUT jack
(see page 13 for details)
(see page 13 for details)
Connected components' digital signal
integrity retained when installed.
integrity retained when installed.
5
DC IN 9V jack
Connect the supplied AC power adaptor
to this jack. (Be sure to use the supplied
AC power adaptor. Using products with
different plug polarity or other
characteristics can cause a malfunction.)
to this jack. (Be sure to use the supplied
AC power adaptor. Using products with
different plug polarity or other
characteristics can cause a malfunction.)