Emerson 3411 User Manual
38
Use of appropriate safety engineered swivel hoist rings in meter end flanges
Section 2: Mechanical installation
Daniel 3410 Series Ultrasonic Gas Flow Meter Installation Manual
June 2014
3-9000-759 Rev D
12.
NEVER lift more than the ultrasonic meter assembly including electronics and
transducers with the hoist rings. The only exception that safe is to lift the meter with
one ASME B16.5 or ASME B16.47 blind flange bolted to each end flange of the meter.
NEVER use the hoist rings on the meter to lift other components such as meter tubes,
piping or fittings attached to the meter. Doing so will exceed the load rating of the hoist
rings.
one ASME B16.5 or ASME B16.47 blind flange bolted to each end flange of the meter.
NEVER use the hoist rings on the meter to lift other components such as meter tubes,
piping or fittings attached to the meter. Doing so will exceed the load rating of the hoist
rings.
13.
Remove the hoist rings from the meter after lifting is completed and store them in an
appropriate case or container per their manufacturer's recommendation.
14.
Apply heavy lubricant or anti-seize to the threads of the plug bolts and reinstall the plug
bolts to keep the tapped holes free of debris and to prevent corrosion.
How to obtain safety engineered swivel hoist rings
TA list of approved manufacturers of safety engineered hoist rings is below:
•
American Drill Bushing Company(
•
Carr Lane Manufacturing Company (
)
Select an approved supplier from the list below. These vendors can supply the safety-
engineered hoist rings. This is not intended to be a complete list.
engineered hoist rings. This is not intended to be a complete list.
•
Fastenal (
•
The appropriate hoist rings can also be purchased directly from Daniel. The following table
provides part numbers for reference:
provides part numbers for reference:
Table 2-1 Hoist ring part number lookup table
Daniel part
number
number
1
1.
Note: The part numbers include only one hoist ring. Two hoist rings are required per meter.
Hoist ring thread size &
load rating
load rating
American Drill
Bushing Co. P/N
Bushing Co. P/N
Carr Lane Manufacturing Co. P/N
1-504-90-091
3/8”-16UNC, 1000 lb.
23053
CL-1000-SHR-1
1-504-90-092
1/2”-13UNC, 2500 lb
23301
CL-23301-SHR-1
1-504-90-093
3/4”-10UNC, 5000 lb.
23007
CL-5000-SHR-1
1-504-90-094
1”-8UNC, 10000 lb.
23105
CL-10000-SHR-1
1-504-90-095
1-1/2”-6UNC, 24000 lb.
23202
CL-24000-SHR-1