Panasonic FV-05-11VKSL1 User Manual

Page of 12
Base PCB box 
Slot
8
INSTALLATION (PLUG ‘N PLAY FUNCTION DEVICES)
Joist
2 Tapping screws
(ST4.2X20)
INSTALLATION (NEW CONSTRUCTION)
Mastic or 
approved 
foil tape
2 Self-drilling screws
Knock-out 
hole
Junction box
cover
Conduit
Circular duct
1. Remove the connector cover 
2. Plug in the specified devices to Base PCB box and fix to the slot, till hear the sound installed in place.
You can purchase the specified Plug ‘N Play devices that are explained on page 6-7 and install them in positions
2
2
2
3
3
3
 from position      ,      or     .
      ,      and     .  Position     can only be used with Multi-Speed module (model FV-05-11VKSL1 already have 
 this control installed), position     and     can be used for any of the other optional control modules.
Connector 
cover 
Squeeze tabs on the Clasp to 
remove. Squeeze, insert and 
release the tabs on Clasp to replace.
2
3
2
3
Joist
2 Tapping screws
(ST4.2X20)
Bend down
4 tabs
Fig.2
Fig.3
Fig.4
1. Disconnet plug connector from receptacle and 
    remove adaptor from fan body by removing the
    machine screw (M4X6) before installation. (Fig.1)  
IMPORTANT:
Remove the tape from damper and adaptor
before installation. As shown below:
The fan position between joists from 16" to 24" 
on center can be adjusted flexibly.
2. Bend down 4 tabs for positioning, install the 
TM
    Flex-Z Fast  bracket to joists by using 2 tapping 
    screws (ST4.2X20) (Please prepare the screws and 
TM
TM
    put on Flex-Z Fast  bracket before Flex-Z Fast  
    bracket is installed on joist). (Fig.2)
3. 
    spacing between joists, and install to joists by 
    using 2 tapping screws (ST4.2X20). (Fig.3)
TM
Adjust the length of Flex-Z Fast  bracket as the 
4. Remove junction box cover and secure conduit 
    or stress relief to junction box knock-out hole.
    (Fig.4)
TM
6. Install the adaptor to Flex-Z Fast  bracket by 
    using 2 self-drilling screws. (Fig.4)
5. Install a circular duct and secure it with clamps, 
    or ties and seal it with mastic or approved foil tape. 
    4 inch 6 inch circular duct is needed to connect to 
    relevant part of common adaptor. (Fig.4)
Tape
Adaptor
Damper
Clasp
CAUTION
Please wear gloves during the installation 
work as follow.
Fan body
Adaptor
Fig.1
Machine screw
(M4X6)