Precor P10 User Manual

Maintenance

6. Observe the belt from the rear of the treadmill for a few

minutes. The belt should remain centered along the

running bed. If it drifts off center, adjust it. Refer to

Adjusting the Running Belt.
Important: Failure to align the belt may cause the belt to tear

or fray, which is not covered by the Precor Limited Warranty.

7. Press the red STOP button to stop the belt.
8. Turn the treadmill OFF.

Adjusting the Running Belt

If you are unsure about adjusting the running belt, call Precor

Customer Support (refer to Obtaining Service).

CAUTION: Take special care when aligning the running belt. Turn

OFF the treadmill while adjusting or working near the rear roller.

Do NOT wear loose clothing or allow your hair to hang loose

during this procedure. Do NOT adjust the running belt when

someone is standing on it. Be very careful to keep your fingers and

any other object clear of the belt and rollers, especially in front of

the roller and behind the deck. The treadmill will not stop

immediately if an object becomes caught in the belt or rollers.

Important: Make all belt adjustments on the adjusting bolts at

the rear corners of the treadmill, using the hex key provided, and

do not turn either bolt more than ¼ turn before checking the

alignment of the running belt again. Overtightening the adjusting

bolts can damage the treadmill.

To adjust the running belt:
1. Locate the adjusting bolts in the end caps at the rear

corners of the treadmill, as shown in the following

diagram.

Figure 29: Location of the adjustment bolt