DISH Network DVR 942 User Manual

3

For AUX mode only. Press 

0 for a second TV, or 1 for a 
second VCR, or 2 for a 
tuner, or amplifier. Then 
press the STAR (*) button.

This step is for programming 
which kind of equipment that 
should be programmed in AUX 
mode. If you’re not 
programming in AUX mode, 
skip to step 4. 

4

Press POWER.

This puts your remote in the 
scan mode.

5

Press  the  UP or DOWN 

ARROW repeatedly until 
the equipment turns off.

As you press the UP or DOWN 
ARROW, the remote tries each 
code in the memory to see if it 
can turn off your equipment. 
When the equipment turns off, 
you have found a code that 
might work.
Note: The mode button for the 
equipment will flash rapidly 
eight times when you’ve 
scanned all the codes for that 
equipment.

6

Press POUND (#).

The mode button flashes three 
times if you have entered the 
code correctly. This stores the 
code you found.

7

Turn the equipment back 

on and try some other but-
tons to make sure they 
work.

Press POWER to turn the 
equipment back on. Try some 
other buttons to make sure they 
work. Sometimes POWER 
works when other buttons 
don’t.

8

If necessary, repeat this 

procedure until you’ve tried 
all the codes.

You may need to repeat the scan 
to find the best code for your 
equipment.

62book.book  Page 5  Tuesday, April 4, 2006  1:45 PM