DISH Network 129418 User Manual

7. Press the plus (+) and minus (-) sides of the 

VOLUME button. The TV’s volume 
changes and the TV mode button lights 
instead of the AUX mode button.

You can set the remote to four different modes to control the receiver 
or other devices. You may need to change the remote address to operate 
the receiver. See Setting Up to Control the Receiver on page 4. You 
must set up the remote to control a device like a TV, VCR, or DVD 
player. See Setting Up to Control Other Devices on page 8. 

Use the remote control’s mode buttons, SAT (satellite receiver), TV 
(for a TV), VCR (for a VCR or a DVD player), and AUX (“auxiliary,” 
for a second TV, a second VCR, a tuner, or an audio amplifier) to set 
the remote to the right mode for the device. 

To change the mode, press the button for the device you want the 
remote to control. The mode button lights for two seconds to show 
you’ve set the remote to that mode.

Press this button to set the remote to SAT (“satellite”) mode to control 
the receiver. The SAT mode button’s back light stays lit for about two 
seconds to show you’ve set the remote to SAT mode. Make sure you 
keep the remote in SAT mode to use the following buttons.

Note: Your satellite receiver may not provide all of the functions 
described as follows. Consult your receiver user’s guide for the 
features your receiver provides.

text_dishpvr.fm  Page 13  Tuesday, March 2, 2004  12:35 PM