Contemporary Research ICW-IRC User Manual

Page of 22
Contemporary Research Corporation 
 
 
 
 
 
IR TV Controller
 
Installation 
 
 
 
AC Power 
1.  Insert DC power supply plug into 12 VDC jack on the IRC.  
2.  Plug power adaptor into AC wall outlet. 
3.  The Net LED should turn on and stay lit. 
 
RF Coax and iCC-Net Operation 
1.  Connect the RF Coax cable into the Antenna/Cable input on the IRC. 
2.  If the iCC-Net signal is operating, the Net LED will blink once per second (ICC2-IRC only). 
 
iCW-Net Connection (ICW-IRC) 
1.  Plug the iCW-Net RJ-45 connector into the iCW-Net input on the ICW-IRC. 
2.  If the iCW-Net signal is operating, the Net LED will blink once per second. 
 
TV Power Sensing 
1.  Press the Power button on the IRC.  
2.  The Power LED should blink, indicating that the IRC knows the TV should be on, but is not sensing the 
presence of TV scanning operation. 
3.  Insert the CC-HSD Scan Sensor plug into the IRC Power Sensor jack. 
4.  Turn on the TV using the TV’s power button. 
5.  Move the CC-HSD sensor block around the rear of the TV to pick up scanning signal from the TV’s 
horizontal transformer 
6.  Watch the IRC Power LED as you move the sensor, stop moving when the LED stops blinking. 
7.  Turn the TV on and off from its own power button, testing if the IRC is reliably sensing power. 
8.  Mount the sensor to the TV, using the enclosed Velcro tape. 
 
Tip:   The best location for the sensor is usually on the lower left rear corner side corner (looking 
from the front), and it may help to rotate the sensor to search for best performance.