Roland GR-33 User Manual

  

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the 
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential 
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in 
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee 
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures:

–   Reorient or relocate the receiving antenna.
–   Increase the separation between the equipment and receiver.
–   Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
–   Consult the dealer or an experienced radio/TV technician for help.

Unauthorized changes or modification to this system can void the users authority to operate this equipment.
This equipment requires shielded interface cables in order to meet FCC class B Limit.

IMPORTANT: THE WIRES IN THIS MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE.

BLUE: 
BROWN: 

As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying 
the terminals in your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED.
Under no circumstances must either of the above wires be connected to the earth terminal of a three pin plug.

NEUTRAL
LIVE

This product complies with the requirements of European Directive 89/336/EEC.

Lithiumbatteri - Eksplosionsfare ved 
fejlagtig håndtering.
Udskiftning må kun ske med batteri af
samme fabrikat og type.
Levér det brugte batteri tilbage til 
leverandøren.

Explosionsfara vid felaktigt batteribyte.
Använd samma batterityp eller en 
ekvivalent typ som rekommenderas av 
apparattillverkaren.
Kassera använt batteri enligt 
fabrikantens instruktion.

Danger of explosion if battery is 
incorrectly replaced.
Replace only with the same or 
equivalent type recommended by the 
manufacturer.
Discard used batteries according to the 
manufacturer’s instructions.

Eksplosjonsfare ved feilaktig skifte av 
batteri.
Benytt samme batteritype eller en 
tilsvarende type anbefalt av 
apparatfabrikanten.
Brukte batterier kasseres i henhold til 
fabrikantens instruks joner.

Paristo voi räjähtää, jos se on
virheellisesti asennettu.
Vaihda paristo ainoastaan 
laitevalmistajan suosittelemaan 
tyyppiin. Hävitä käytetty paristo 
valmistajan ohjeiden mukaisesti.

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du  Canada.

 

 

 

To resize thickness, move all items on the front cover to left or right

 

001

 

• Before using this unit, make sure to read the 

instructions below, and the Owner’s Manual.

..........................................................................................................

 

002c

 

• Do not open (or modify in any way) the unit or its 

AC adaptor.

..........................................................................................................

 

003

 

• Do not attempt to repair the unit, or replace parts 

within it (except when this manual provides 
specific instructions directing you to do so). Refer 
all servicing to your retailer, the nearest Roland 
Service Center, or an authorized Roland 
distributor, as listed on the "Information" page.

..........................................................................................................

 

004

 

• Never use or store the unit in places that are:

• Subject to temperature extremes (e.g., direct 

sunlight in an enclosed vehicle, near a heating 
duct, on top of heat-generating equipment); or 
are

• Damp (e.g., baths, washrooms, on wet floors); 

or are

• Humid; or are

• Exposed to rain; or are

• Dusty; or are

• Subject to high levels of vibration.

..........................................................................................................

 

007

 

• Make sure you always have the unit placed so it is 

level and sure to remain stable. Never place it on 
stands that could wobble, or on inclined surfaces.

..........................................................................................................

 

008c

 

• Be sure to use only the AC adaptor supplied with 

the unit. Also, make sure the line voltage at the 
installation matches the input voltage specified on 
the AC adaptor’s body. Other AC adaptors may 
use a different polarity, or be designed for a 
different voltage, so their use could result in 
damage, malfunction, or electric shock.

..........................................................................................................

 

009

 

• Do not excessively twist or bend the power cord, 

nor place heavy objects on it. Doing so can 
damage the cord, producing severed elements and 
short circuits. Damaged cords are fire and shock 
hazards!

..........................................................................................................

 

010

 

• This unit, either alone or in combination with an 

amplifier and headphones or speakers, may be 
capable of producing sound levels that could 
cause permanent hearing loss. Do not operate for 
a long period of time at a high volume level, or at 
a level that is uncomfortable. If you experience 
any hearing loss or ringing in the ears, you should 
immediately stop using the unit, and consult an 
audiologist.

..........................................................................................................

 

011

 

• Do not allow any objects (e.g., flammable material, 

coins, pins); or liquids of any kind (water, soft 
drinks, etc.) to penetrate the unit.

..........................................................................................................

 

012b

 

• Immediately turn the power off, remove the AC 

adaptor from the outlet, and request servicing by 
your retailer, the nearest Roland Service Center, or 
an authorized Roland distributor, as listed on the 
"Information" page when:

• The AC adaptor, the power-supply cord, or the 

plug has been damaged; or

• Objects have fallen into, or liquid has been 

spilled onto the unit; or

• The unit has been exposed to rain (or otherwise 

has become wet); or

• The unit does not appear to operate normally or 

exhibits a marked change in performance.

..........................................................................................................

Used for instructions intended to alert 
the user to the risk of injury or material 
damage should the unit be used 
improperly. 

* Material damage refers to damage or 

other adverse effects caused with 
respect to the home and all its 
furnishings, as well to domestic 
animals or pets. 

Used for instructions intended to alert 
the user to the risk of death or severe 
injury should the unit be used 
improperly. 

The 

●

 symbol alerts the user to things that must be 

carried out. The specific thing that must be done is 
indicated by the design contained within the circle. In 
the case of the symbol at left, it means that the power-
cord plug must be unplugged from the outlet. 

The      symbol alerts the user to important instructions 
or warnings.The specific meaning of the symbol is 
determined by the design contained within the 
triangle. In the case of the symbol at left, it is used for 
general cautions, warnings, or alerts to danger. 

The       symbol alerts the user to items that must never 
be carried out (are forbidden). The specific thing that 
must not be done is indicated by the design contained 
within the circle. In the case of the symbol at left, it 
means that the unit must never be disassembled.