Roland GR-33 User Manual
98
Chapter 10 Other Convenient Functions
■
Terminating Transmission of the MIDI
Controller No. 7
Controller No. 7
1. Press [SYSTEM] to enter System mode.
2. Press [PARAMETER] to select “VOL SEND SW.”
fig.10-04
3. Turn [VALUE] to select “Off.”
4. Press [PLAY] to return to Play mode.
* This is a system-wide setting, and not a patch setting, so there
is no need to perform a patch write operation. The setting is
automatically stored in memory even after the power is
switched off.
automatically stored in memory even after the power is
switched off.
This stops the transmission of Control Change No. 7 from
MIDI OUT, eliminating the problem described above.
MIDI OUT, eliminating the problem described above.
* This also terminates transmission of Control Change No. 7
messages for other volume-related control, so this setting
should not used except when necessary. Please note that once
transmission has been disabled, it remains so until you switch
the setting back to “On” or restore system-related settings to
their default values by performing a Factory Reset (p. 16).
should not used except when necessary. Please note that once
transmission has been disabled, it remains so until you switch
the setting back to “On” or restore system-related settings to
their default values by performing a Factory Reset (p. 16).
Terminating Transmission of the Bend Range Request Message
The GR-33 informs any external MIDI device of the GR-33’s
current Bend Range setting each time a new patch is selected.
current Bend Range setting each time a new patch is selected.
The messages used here are MIDI RPN (Registered
Parameter Number) “Pitch Bend Sensitivity” messages—that
is, Control Change messages No. 100, No. 101, No. 6, and No.
38.
Parameter Number) “Pitch Bend Sensitivity” messages—that
is, Control Change messages No. 100, No. 101, No. 6, and No.
38.
If it is necessary for some reason to stop the transmission of
these messages—such as when you wish to reduce the
number of messages sent to a sequencer as you change
patches on the GR-33—follow the steps below to turn off this
function.
these messages—such as when you wish to reduce the
number of messages sent to a sequencer as you change
patches on the GR-33—follow the steps below to turn off this
function.
1. Press [SYSTEM] to enter System mode.
2. Press [PARAMETER] to select “BEND REQ SW.”
fig.10-05
3. Turn [VALUE] to select “Off.”
4. Press [PLAY] to return to Play mode.
* This is a system-wide setting, and not a patch setting, so there
is no need to perform a Patch Write operation. The setting is
automatically stored in memory, even after the power is
switched off.
automatically stored in memory, even after the power is
switched off.
Once you’ve done this, no Bend Range Request messages
(MIDI Pitch Bend Sensitivity) are sent when changing
patches.
(MIDI Pitch Bend Sensitivity) are sent when changing
patches.
* Please note that once transmission has been disabled, it
remains so until you return the setting to “On” or restore
system-related settings to their default values by performing a
Factory Reset (p. 16).
system-related settings to their default values by performing a
Factory Reset (p. 16).