Manualsbrain.com
  1. Manuals
  2. Brands
  3. Konica Minolta
  4. VI-910
  5. User Manual

Konica Minolta VI-910 User Manual

Download
Page of 270
259
Chapter 
3
Error
Messages
Error Message (Alphabetically)
Cause
Action
AF error. Laser barrier may be 
closed
The digitizer was not ready due to an 
AF error.
Click the [OK] button to close the mes-
sage dialog box.
AF error.
The digitizer was not ready due to an 
AF error.
Click the [OK] button to close the mes-
sage dialog box.
Calculation disable.
Failed to calculate using the specified 
corresponding points.
Click the [OK] button to close the mes-
sage dialog box.
*When selecting correspondence points, 
you must select points so that they are 
sufficiently spaced and so that are within 
the range that can be specified within the 
element’s colorimage window.
Cannot display wireframe.
The command was selected even though 
the currently displayed color image was 
the one added to the data taken by the 
digitizer.
Click the [OK] button to close the mes-
sage dialog box.
Cannot show information of more 
than 20000 points. (Number of 
selected points – 20000) Points 
will be omitted.
More than 20000 points were selected.
Click the [OK] button to display the 
[Info-Points] dialog box. Information for 
the extra points (i.e. the points exceeding 
– 20000) will not be included.
Choose more than 2 points.
An attempt was made to extract a line 
without selecting two or more points.
Click the [OK] button to close the mes-
sage dialog box.
Choose more than 3 points.
An attempt was made to extract a face 
or circle without selecting three or more 
points.
Click the [OK] button to close the mes-
sage dialog box.
Choose more than 4 points.
An attempt was made to extract a sphere 
without selecting four or more points.
Click the [OK] button to close the mes-
sage dialog box.
Create Meshes Fault!
Failed to fill holes.
(This message appears if creation of 
meshes fails with “Fillholes by meshes” 
or “Replace meshed” selected.)
Click the [OK] button to close the mes-
sage dialog box.
Design value is same as that of 
others.
The design values of the extracted point 
are the same as those of the extracted 
line.
Click the [OK] button to close the mes-
sage dialog box.
Extracted line’s vector overlaps
The extracted line’s vector is the same 
as the other line’s vector.
Click [OK] button to close message 
dialog box.
Extracted point overlaps
The extracted coordinate (X, Y, Z) is the 
same as the other’s coordinate.
Click [OK] button to close message 
dialog box.
Extraction failure. Please select 
again.
Fail extraction of Point, Line or Face.
Click [OK] button to close message 
dialog box.
File write error.
A write error occurred, for instance, due 
to an excessively long file path name.
Click the [OK] button to close the mes-
sage dialog box.
File write error: user preferences.
A write error occurred.
Click the [OK] button to close the mes-
sage dialog box.
No preference file will be created even if 
the [OK] button is clicked.
(The settings will be lost if this software 
is exited.)
Error Messages
The following error messages appear if incorrect operation is performed or an abnormality occurs. If an error
message appears, take the appropriate corrective actions as shown in the table below.