Universal Remote Control URC-100 User Manual

Page of 56
13
U R C - 1 0 0
Advanced Setup
After you’ve finished all your basic setup, you can 
choose to make operation easier by customizing the 
Unifier just the way you want, using the Advanced Setup 
features described in this section.
Own Two VCR’s? 
Set Aux to be VCR2
Any device button can be setup for ANY type of 
component (for example, you can make the AUX device 
button operate a second VCR). To setup a device button 
for a different type of component, use these steps:
Power on the A/V component you wish to setup, so that
you can test codes by sending power off commands.
Refer to the pre-programmed code tables on pages 
25 - 46 and write down the code numbers listed 
for your A/V component. 
Press and hold both the SHIFT and ENT (Enter) 
buttons for approximately three seconds. The top 
of the display will blink “SET” for a moment.
Note: You have 30 seconds for each step, otherwise the 
Unifier will time out automatically. 
1
3
2
SHIFT
Button
ENT
Button