One For All 24993 User Manual

8

If your device does not respond after you have 

tried all the codes for your brand, or if your brand is 

not listed, try searching for your code by following 

these steps.

1.  Manually turn on the device (

, 

, etc.) to 

be controlled.

2.  Press and hold the 

SETUP button until 

the red indicator stays on, then release 

the 

SETUP button.

3.  Press and quickly release the desired 

mode button (

TV, DVR, etc.). The red 

indicator blinks off once.

4.  Press the 

CHAN+ button repeatedly 

(up to 300 times) until the device to be 

controlled changes channel. 

The red indicator blinks off 

with each button press. If 

you accidentally overshoot 

the code required, press the 

CHAN- button to backtrack through the library 

until the device changes channel. Pressing 

CHAN+ changes direction to forward again. 

.  Press and release 

ENTER to install the code. 

Most users will store DVR codes under the 

button, Cable codes under 

CABLE, etc. If 

(for example) you want to store a DVR code 

under 

CABLE, first follow the procedure 

for Direct Code Entry (page 7) and press 

CABLE in step 2 of Direct Code Entry, then 

enter ANY DVR code in step 3 of Direct Code En-

try. Then follow the steps above for Code Search.

Note:  If the device does not have a CHAN+ button, 

use 

PLAY (DVR only) or POWER instead. Code Search 

starts from the currently stored three digit number under 

that mode. Sometimes the first code that “works” with 

your device may only allow limited functionality (e.g., 

the MENU button might not work). There may be a code 

that performs more functions. Continue the code search 

process until the best code is found.