Marantz RC1200 User Manual

10

If it is left for approximately 1 minute without
pressing any buttons, all items on the LCD
will go off except the function indicator.
Even if the display goes off, the remote
controller will retain the status established
before the display went off.  When any
button is pressed, the display will appear
on the whole LCD display.

The remote controller is capable of learning
and memorizing the remote control codes
used by almost any other remote controller
you may already own.
• If no commands have been programmed for

a particular function button, the remote
controller will transmit whatever codes have
been factory preset.

• The following example shows how to

program your remote controller and how to
use the codes for a laser disc player (LD).

• A different code can be programmed for

each function in each one of the buttons.
The COPY mode described later (on page
34) comes in handy if the same code is to
be sent by all the functions.

• The remote controller infrared receiver is

located at the top of the remote controller.

Use a ballpoint pen or other sharp point to
press the 

button z until 

is

displayed and starts to blink.  Each time
the button is pressed, the display cycles
through the modes one by one in
sequence: 

→

 

→

 

 

→

 

 

→

 

, etc.

• The USE mode is selected when the

MODE button is pressed after an
operation in the LEARN, NAME or
other mode.

Place the laser disc’s remote controller so
that its infrared signal transmitter is facing
the infrared signal receiver on the
Marantz remote controller at a distance of
about 5 centimeters (2 inches).

 ON

 

 OFF

 ON 

/OFF

 S

OURCE

 MA

CRO 

 MO

DE 

LEARNING  REMOTE

CONTROL

  RC 70

00

5cm