Universal Remote Control OCE-0085A User Manual

Page 30

Erasing Commands -

Overview

You can erase a single learned command, all
learned commands in each component mode,
SimpleSound programming, MacroPower com-
mands, or re--set the remote to original factory
default settings.

Erasing a Single Learned Command from
One Component

STEP 1:

Press the component button where

the learned command is stored and the [ENTER]
button at the same time for two seconds until the
component LED light turns on.

IMPORTANT:

You have 30 seconds to per-

form the next step while you are in programming
mode. If you do not press a button within 30 sec-
onds, the component LED light will turn off. The
remote will exit the programming mode and you
will have to start over.

STEP 2:

Press and hold the button you

want to erase for two seconds. The compo-
nent LED light will blink twice to confirm the
erasure.

STEP 3:

Repeat Step 2 to erase any other

buttons in the selected component mode.

STEP 4:

To exit Erase mode, press and

hold both the component button and the
[ENTER] button at the same time until the
component LED light blinks three times.

COMPONENT

BUTTONS

ENTER