Universal Remote Control R6 User Manual
Page 26
Erasing Commands --
Overview
You can erase a single learned command, all
learned commands in each component mode,
SimpleSound programming, MacroPower com-
mands, or re--set the remote to original factory
default settings.
learned commands in each component mode,
SimpleSound programming, MacroPower com-
mands, or re--set the remote to original factory
default settings.
Erasing a Single Learned Command from
One Component
One Component
STEP 1:
Press the component button where the
learned command is stored and the ENTER buttons
at the same time for two seconds until the compo-
nent LED light turns on.
at the same time for two seconds until the compo-
nent LED light turns on.
IMPORTANT:
You have 30 seconds to perform
the next step while you are in programming mode.
If you do not press a button within 30 seconds,
the component LED light will turn off. The remote
will exit the programming mode and you will have
to start over.
If you do not press a button within 30 seconds,
the component LED light will turn off. The remote
will exit the programming mode and you will have
to start over.
COMPONENT
BUTTONS
ENTER
STEP 2:
Press and hold the button you want to
erase for two seconds. The component LED light
will blink twice to confirm the erasure.
will blink twice to confirm the erasure.
STEP 3:
Repeat Step 2 to erase any other buttons
in the selected component mode.
STEP 4:
To exit Erase mode, press and hold both
the component button and the ENTER (ENT) button
at the same time until the component LED light
blinks three times.
at the same time until the component LED light
blinks three times.