Sunwave Tech. SRC-7000 User Manual

You see an “error” display 
during operation. 

• 

The key that you pressed has not been taught or input the IR 
code. 

• 

Teach the key via learning procedure. (P.37) 

 

IR Learning is not 
successful. 

• 

Do not use the learn function near an incandescent lamp. 

• 

Memory capacity is full (64 keys for each device.). 

• 

Replace new batteries in the SRC-7000 and the remote you are 
trying to configure. 

• 

Keep the learning distance between the remote control and 
SRC-7000’s learning eye about 2~4 inches apart (5-10cm). 

• 

The learning process has no errors, but you still can’t control 
your target devices:  

-  The battery in the target remote doesn’t have enough 

power. 

-  Original remote might not be compatible with learning 

procedure. Repeat the learning procedure again. 

-  If you still can’t solve the problem, contact SUNWAVE for 

help. 

Macro does not work. 

• 

Be sure to aim the SRC-7000 at the devices while the Macro 
commands are being sent. 

• 

Macro was not properly set up.  Repeat macro set-up 
procedure. (P.42) 

A key of your existing 

remote performs two or 
more functions 

• 

Some remotes issue multiple commands when a key is held 
down.  Please be sure to teach different keys of SRC-7000 for 
these different commands.  

• 

Each key of SRC-7000 can learn 6 commands in a Cycle key. 
(P.40) 

The LCD screen turns off. 

• 

The SRC-7000 is preset automatically to switch the LCD off 
after 1 minute by default if left unused. You can also setup the 
idle time to turns off the LCD. (P.54) 

• 

You can turn on the SRC-7000 again as followed: 

-  Tap the touch screen 
-  Pick up the SRC-7000 
-  Press the hard key 

 

The touch panel isn’t 
sensitivity 

 
• 

Please re-calibrate your touch panel (P.17)