Philips DCR 2021 User Manual
63
EN
Your receiver is connected to the cable wall socket,TV
set and other equipment according to the diagrams in
chapter Quick installation.
1 Switch on your TV set and select a channel.
2 Plug your receiver into the mains.Wait for
set and other equipment according to the diagrams in
chapter Quick installation.
1 Switch on your TV set and select a channel.
2 Plug your receiver into the mains.Wait for
approximately 20 seconds for the welcome screen
to appear.
to appear.
3 Wait for a few seconds for the First installation
screen to appear.
5.1 First installation settings
4 Set your favourite Language setting.
5 Set your TV display format.
6 Press OK to start scanning for channels.
5 Set your TV display format.
6 Press OK to start scanning for channels.
5.2 Channel scan
During the scanning process, the following information
is reported on screen:
is reported on screen:
• number of TV and radio channels detected
• scanning progress, indicated as a percentage
• strength of the signal and the quality of reception.
• scanning progress, indicated as a percentage
• strength of the signal and the quality of reception.
Channel scan may take up to twenty minutes. If you press
EXIT during the scanning process, you interrupt the
scanning. In this case, none of the channels found are
stored.
EXIT during the scanning process, you interrupt the
scanning. In this case, none of the channels found are
stored.
When scanning has been successfully completed, a
completion message is displayed.
completion message is displayed.
7 Press OK; a new screen appears indicating that a
search for new software is in progress.
8 Press EXIT to stop searching and tune the receiver
to the first channel in the main TV list.
Alternatively, wait for software detection, and then
proceed as described in paragraph 10.5.5.2.
proceed as described in paragraph 10.5.5.2.
5 First installation
DCR 2021_Premiere_indice 1b 7/03/06 11:45 Page 63