Panasonic CY-TUN133W User Manual

4

5

 This unit is designed for use exclusively in 

 Do not operate the unit for a prolonged period with 

  Operating the audio system for a long period of time 

with the engine turned off will drain the battery. 

 Do not expose the unit to direct sunlight or excessive 

  Otherwise these will raise the interior temperature 

of the unit, and it may lead to smoke, fi re, or other 
damage to the unit. 

 Do not use the product where it will be exposed to 

  Exposure of the unit to water, moisture, or dust may 

lead to smoke, fi re, or other damage to the unit. Make 
especially sure that the unit does not get wet in car 
washes or on rainy days.

 If your car is equipped with air bag and/or anti-theft 

 FAILURE TO FOLLOW THE PROCEDURE MAY RESULT 

 Refer wiring and installation to qualifi ed service 

  Installation of this unit requires special skills and 

experience. For maximum safety, have it installed by 
your dealer. Panasonic is not liable for any problems 
resulting from your own installation of the unit. 

 Follow the instructions to install and wire the product.  
  Not following the instructions to properly install and 

wire the product could cause an accident or fi re. 

 Take care not to damage the leads.  
  When wiring, take care not to damage the leads. 

Prevent them from getting caught in the vehicle 
chassis, screws, and moving parts such as seat rails. 
Do not scratch, pull, bend or twist the leads. Do not run 
them near heat sources or place heavy objects on them. 
If leads must be run over sharp metal edges, protect 
the leads by winding them with vinyl tape or similar 
protection. 

 Use the designated parts and tools for installation.  
  Use the supplied or designated parts and appropriate 

tools to install the product. The use of parts other than 
those supplied or designated may result in internal 
damage to the unit. Faulty installation may lead to an 
accident, a malfunction or fi re.  

 Do not install the product where it is exposed to 

  Avoid slanted or strongly curved surfaces for 

installation. If the installation is not stable, the unit may 
fall down while driving and this can lead to an accident 
or injury. 

 Ware gloves for safety. Make sure that wiring is 

 To prevent damage to the unit, do not connect the 

 Never mount the unit in any of the following locations 

to avoid damage due to overheating;

  • Near the heater port. 
  •  Places like the dashboard or rear deck, where it may 

be exposed to direct sunlight. 

 Do not mount the unit near the door, where it could be 

exposed to rain. 

 You run the risk of interfering with the mounting or 

causing damage by drilling into the gas tank, a wiring 
harness, or other component.

 Note that if your car has a driving computer or a 

navigation computer, disconnecting the cable from the 
battery may clear the memory. 

 Fit a vinyl cap over unused connection terminals, to 

prevent contact with metal parts etc.

Proper Use of the Batteries 
 Use only specifi ed battery (CR2025).
 Match the polarity of the battery with the () and () 

marks in the battery case. 

 Replace a dead battery as soon as possible. 
 Remove the battery from the remote control unit when 

not using it for an extended period of time. 

 Insulate the battery (by placing them in a plastic bag 

or covering them with vinyl tape) before disposal or 
storage. 

 Do not disassemble, recharge, heat or short the battery. 

Do not throw a battery into a fi re or water. 

 Follow local regulations when disposing of a battery. 
 Improper use of a battery may cause overheating, an 

explosion or ignition, resulting in injury or a fi re.  

In case of battery leakage
 Thoroughly wipe the battery liquid off the battery case 

and insert new battery. 

 If any part of your body or clothing comes into contact 

with battery liquid, wash it with plenty of water. 

 If battery liquid comes into contact with your eyes, 

wash them with plenty of water and get immediate 
medical attention. 

 Park your car in a safe and pull the parking brake (side 

brake) lever before watching the monitor. 

 If a rear monitor (option) is connected to this unit, you 

can continually see the rear monitor image even if the 
parking brake (side brake) has not been pulled on. 

3

4

Note:
 Only English is displayed on the OSD screen.