Motorola DCT1800 User Manual
Installation 3-9
DCT1800 Installation Manual
Operational Check
The operational check tests the communication link between the remote control and the
DCT1800. The procedures verify the DCT1800 response to remote control commands.
Table 3-1 lists the operational check procedures:
DCT1800. The procedures verify the DCT1800 response to remote control commands.
Table 3-1 lists the operational check procedures:
Table 3-1
Operational check
Operational check
Feature Testing
Procedure
Power on
!
Press
POWER
to turn on the DCT1800.
!
Turn on the TV and tune it to the output channel of the DCT1800 (channel 3
or 4).
or 4).
Channel Selection
Tune to several channels by entering the channel number with the numeric keys on
the remote control.
the remote control.
If the DCT1800 does not operate properly, refer to Section 4, “ Troubleshooting” .
Cold Initialization
The DCT1800 has no front panel buttons. To perform a cold initialization, or reset, use the
remote control.
remote control.
To execute a cold initialization:
1
Hold down any key on the remote control while disconnecting and reconnecting AC power to
the DCT1800.
the DCT1800.
After booting up, the
POWER
LED on the DCT1800 front panel will flash.
2
Within 3 seconds, press the 3 key on the remote control.
The
POWER
LED on the DCT1800 front panel flashes at a decreased rate.
3
Within 3 seconds, press the 2 key on the remote control.
The
POWER
LED on the DCT1800 front panel flashes at an increased rate.
4
Within 3 seconds, press the 8 key on the remote control to initiate the cold reset.
During the cold initialization procedure, if the appropriate remote control key is not pressed
within the three-second time period, the procedure terminates and the DCT1800 resumes
normal operation.
within the three-second time period, the procedure terminates and the DCT1800 resumes
normal operation.