Sony DHG-M55CV User Manual

Try programming the remote using the other codes listed for your 
brand. If you still cannot get your component to respond after trying 
all the codes, your component may not be compatible with this 
remote. If this happens, you must use your component’s remote to 
operate it. Or, as an alternative, you can use the following 
instructions to program the Digital Network Receiver’s remote to 
control the volume level.

If you cannot successfully program the Digital Network Receiver’s 
remote to control your TV (as described on page 6), you can still use 
this remote to control the volume level (and 

MUTE

) that is output from 

the Digital Network Receiver’s audio 

LINE OUT 1 (TV)

 and 

TO TV/VCR

 jacks. 

Press the 

CODE SET

 button.

Enter 

200

 using the 0-9 buttons.

Press the 

#

 button (located below the “

9

” button).

Aim the remote control at the Digital Network Receiver.

Press the 

VOL+, VOL-, 

or

 MUTE 

button. If the volume level responds, 

you’re done.

Try programming the remote control as described on page 6, or you 
can continue to control only the volume level as described in this 
section. 

When the batteries need to be replaced, insert two size AA batteries 
by matching the + and 

–

 on the batteries to the diagram inside the 

battery compartment.Then replace the battery compartment lid. 

✍

Remove the batteries to avoid damage from possible battery leakage whenever you 
anticipate that the remote control will not be used for an extended period.

Handle the remote control with care. Avoid dropping it, getting it wet, or placing it in 
direct sunlight, near a heater, or where the humidity is high.

CV.book  Page 7  Thursday, November 30, 2000  2:13 PM