Tunturi R30 User Manual

start measuring at the same heart rate level as 
precisely as possible.

 To switch back to the main display by pressing 

RESET. The console will also automatically 
switch to the main display one minute after the 
completion of the measurement.

Move the device according to the following 
instruction, because lifting the cycle incorrectly 
may strain your back or cause other risk of 
accidents:

Stand behind the device and grip the rail with one 
hand and the seat with the other. Tilt the device 
so that is rests on the transportation wheels. Move 
the device by wheeling it on transportation wheels. 
Lower the device onto floor while holding on to 
the rail and the seat,all the time remaining behind 
the device. 

Transport the equipment with caution over uneven 
surfaces, for example over a step. The equipment 
should never be transported upstairs using the 
wheels over the steps, instead it must be carried. 
We recommend that you use a protective base 
when transporting the equipment.

To prevent malfunctioning of the cycle, store in 
a dry place with as little temperature variation as 
possible, protected from dust.

 The R30 requires very little maintenance. 

Check, however, from time to time that all screws 
and nuts are tight. 

Clean the cycle with a damp cloth. Do not use 

solvents.

Never remove the protective covers.

Clean the inner surfaces of the rail if necessary 

so that the seat moves as smoothly and quietly as 
possible. If necessary, you may improve the seat 
movement by adding paraffin to the surface of the 
rails.

The console gives a warning signal before the 
change of batteries is due. Remove the battery 
compartment cover from the back side of the meter 
and remove old batteries. Place new batteries in 
the holder (note the direction of the batteries) and 
reattach the cover.

To minimize the strain on the resistance 
mechanism, we recommend that the resistance 
adjustment knob is set to position 1 after every 
training session.

Despite continuous quality control, defects and 
malfunctions caused by individual components 
may occur in the equipment. In most cases it’s 
unnecessary to take the whole device in for repair, 
as it’s usually sufficient to replace the defective part. 

If the equipment does not function properly 
during use, contact your Tunturi dealer 
immediately. Always give the model and serial 
number of your equipment. Please state also the 
nature of the problem, conditions of use and 
purchase date. 

If you require spare parts, always give the model, 
serial number of your equipment and the spare 
part number for the part you need. The spare part 
list is at the back of this manual. Use only spare 
parts mentioned in the spare part list.

Length ......................................... 200  cm
Width  .......................................... 48 cm
Height  .......................................... 56 cm
Weight  .......................................... 46 kg

The R30 meets the requirements of the EU’s 
EMC Directives on electromagnetic compatibility 
(89/336/EEC). This product therefore carries the 
CE label.

The R30 meets EN precision and safety standards 
(EN-957).

Due to our continuous policy of product 
development, Tunturi reserves the right to change 
specifications without notice. 

The instructions must be followed carefully 

in the assembly, use and maintenance of your 
equipment. The warranty does not cover damage 
due to negligence of the assembly, adjustment 
and maintenance instructions described herein. 
Changes or modifications not expressly approved 
by Tunturi Oy Ltd will void the user's authority to 
operate the equipment! 

R30.indd   8

R30.indd   8

5.9.2005   11:07:51

5.9.2005   11:07:51