Braun 403 User Manual

e

m

a

r

F eb

u

T

Vehicle lift access door opening 

must meet specified dimensions.

Nonmodified OEM full size van floors meet 

all requirements for Vangater II.  Nonmodi-

fied OEM mini van floors meet all require-

ments for Mini Vangater II.  

 

Must meet or exceed nonmodified 

OEM floor section.

1.  Remove the lower slide door stop.

2.  With Power Door:  Door stop not 

used.

Without Power Door:  Drill (2) holes 

in the lower door stop at dimensions 

shown in Figure B.

3.  Replace door stop, locating on the 

(2) drilled holes (provides adequate 

clearance).

2-3/4"

1-7/16"

Drill (2) 5/16" diameter holes.

Place lift in approximate 

position.  Note:  Hoist 

or other lifting device is 

recommended.  

Position wedge plate(s) 

to achieve a 1/2" pre-

load at right inboard 

corner of platform.  See 

Figures C and D.

Minimum 1" clearance 

between lift and vehicle.  

See Figure E.

Maximum 1/2" between 

inboard locator and floor 

when locator is deployed.  

See Figure E.

Minimum 3/4" clearance 

between door and verti-

cal arm.  See Figures F 

and G.

Minimum 3/4" 

Clearance

Minimum 3/4" 

Clearance

Position wedges as 

needed for 1/2" preload.

Stepwell

Floor

Inboard

Locator

1/2"

Minimum 1" Clearance