Quantum 1121 3SP User Manual
Quantum 1121 Series
www.pridemobility.com
21
V . C O M F O R T A D J U S T M E N T S
Figure 15. Seat Position Adjustment
9. Reinstall the retaining clip into each seat tower.
10. Reinstall the seat.
11. Plug the controller connector(s) into the electronics
tray.
NOTE: Make sure the seat latch safety is flipped
down before using the power chair seat.
Seat Position Adjustment
You can move the seat forward or rearward by chang-
You can move the seat forward or rearward by chang-
ing the extrusion mounting position.
To change the position:
1. Turn off the power to the controller.
2. Remove the seat.
3. Remove both extrusions from the bottom of the
seat. See figure 10.
4. Reposition the extrusions on a different set of
mounting holes. You must move both extrusions
the same number of holes either forward or
backward. See figure 15.
5. Fasten the extrusions back onto the bottom of the
seat.
6. Reinstall the seat.
Manual Recline Seatback Adjustment
If your power chair is equipped with a reclining seat,
If your power chair is equipped with a reclining seat,
you can adjust the seatback angle with the seatback
release lever. The lever is located on the right side of
the seat base.
To adjust the seatback angle:
1. Pull up on the seatback release lever.
2. Move the seatback down or up to the desired
position.
3. Release the lever.