Quantum 06 edge va User Manual

www.pridemobility.com

Q6 Edge VA

You may need the following to make comfort

adjustments:

metric/standard socket set and ratchet

adjustable wrench

metric/standard hex key set

thread lock

Seat Height and Seat Angle Adjustment
If your power chair is not equipped with a transit

securement system, you can change the seat height to

one of three positions by raising the front and rear tra-

peze bars. If you raise or lower only one trapeze bar

(front or rear), you can also change the seat base angle

(dump).

MANDATORY! If your power chair is

equipped with a transit securement

system and any adjustment to the seat

height or seat angle is necessary,

contact your Quantum Rehab Provider.

These comfort adjustment can only be

made by a Quantum Rehab Provider.

To change the seat height:

1. Turn off the power to the controller.

2. Make sure the power chair is in drive mode.

3. Unplug the controller connector(s) from the power

base. See figure 3.

4. Flip up the seat latch safety. See figure 7.

5. Squeeze the seat latch and release the seat from the

front trapeze bar.

6. Slide the seat forward and remove it from the

power base.

V . C O M F O R T A D J U S T M E N T S

COMFORT ADJUSTMENTS

After becoming familiar with your power chair’s operation, you may find the need to make some adjustments to

increase your comfort, such as seat height and angle, armrest width, armrest angle and height, foot platform

height, depth, and angle, and controller position.

NOTE: If your power chair is equipped with a Specialty Seat, Synergy Seat, or TRU-Balance Power Position-

ing System, refer to the seat adjustment information contained in separate manuals. If your power chair is

equipped with a contoured seating system, refer to the following information.

WARNING! The center of gravity of your power chair was factory set to a position that meets the

needs of the demographic majority of users. Your Quantum Rehab Provider has evaluated your

power chair and made any necessary adjustments to suit your specific requirements. Do not

change your seating configuration without first contacting Pride Mobility Products or your

Quantum Rehab Provider.

WARNING! Some power chair components are heavy. You may need assistance to lift or carry

them. Please refer to the specifications table for specific component weights before you

disassemble the power chair.

WARNING! Remove the occupant from the power chair before making any adjustments.

Figure 13. Seat Height/Angle Adjustment—UMS

TRAPEZE BARS

HARDWARE

SEAT INTERFACE

WELDMENT