Quantum 1121 3MP User Manual

Quantum 1121 Series

www.pridemobility.com

19

1. Set the seat towers to the desired height. To change

the seat height, see V. “Comfort Adjustments.”

2. Tilt the seat back, and slide the rear extrusion onto

the rear trapeze bar.

3. Lower the front extrusion onto the front trapeze bar

until the seat latches into place.

4. Flip the seat latch safety down.

WARNING! Make sure the seat latch

safety is flipped down before using

your power chair.

5. Install the controller into one of the armrests. See V.

“Comfort Adjustments.”

6. Plug the controller harness into the connector on the

electronics tray.

7. Route the harness to ensure that the harness cannot

be pinched in the seat hinge. See figure 11 or 12.

8. Secure the controller harness to the armrest receiver

with one or more wire ties.

MANDATORY! Prevent controller

harness damage! Avoid routing the

controller harness on the outside of the

armrest pad. Route the harness under

the armrest or toward the inside of the

armrest pad. Use correct tie-down

points for the controller harness to

prevent the harness from getting

caught in the drive tires, pinched in the

seat frame, or damaged when passing

through doorways.

I V .   A S S E M B L Y