Tektronix WFM 601A User Manual

Cursor Commands

WFM 601A, WFM 601E & WFM 601M User Manual

The commands in this section allow you to select and move the voltage and
timing cursors on the waveform monitor. They also allow you to make measure-
ments using the cursors.

Enables any one of the following cursor types:

 VOLT provides two voltage cursors and a track control.

 TIME provides two time cursors and a track control.

 MARK provides three amplitude markers.

 VOLT_TIME provides both VOLT and TIME cursors. Use CUR:CONTROL

to select either the voltage or time cursors.

CURsor:SELect  <VOLT | TIME | VOLT_TIME | MARK | NONE>
CURsor[:SELect]?

<VOLT | TIME | VOLT_TIME | MARK | NONE>

cur:sel volt
cur:select mark
cursor:select volt_time

cur?
:CURSOR:SELECT VOLT_TIME;CONTROL TIME
cursor:select?
:CURSOR:SELECT VOLT_TIME