Tektronix WFM 601A User Manual

Eye Pattern Commands

WFM 601A, WFM 601E & WFM 601M User Manual

The commands in this section allow you to select either the Eye or EQEye
displays and to toggle between the Overlay and 10 Eye modes. Use the
command DISPlay:SINGLE:EYe to enable the Eye display.

Selects either the Flat (or raw) digital data stream or an Equalized data stream for
the Eye display. The Flat mode corresponds to the EYE bezel button selection in
the Eye display mode. The EQEYE mode compensates for cable loss in a long
cable by applying receiver equalization to the signal.

EYe:DISPlay  <FLAT | EQEYE>
EYe[:DISPlay]?

<FLAT | EQEYE>

ey:disp eqeye

eye:disp?
:EYE:DISPLAY  EQEYE

Selects the trigger mode for the Eye display. OVERLAY displays three eyes and
EYE10 displays 10 eyes.

EYe:MODE  <OVERLAY | EYE10>
EYe[:MODE]?

<OVERLAY | EYE10>

eye:mode eye10

eye:mode?

:EYE:MODE  EYE10