Anritsu MG3641A User Manual

SECTION 4 OPERATING INSTRUCTIONS

4-38

Once you have set the sweep parameters, you execute the sweep.

(7) Press the "Rtn" [F5] key in the "Sweep Parameter" menu

to return to the "Sweep" menu.

(8) Pressing the "

" [F2] key starts the sweep.

(9) Pressing the "

■" [F3] key with the sweep under way

aborts the sweep.

Moreover, pressing " " key will hold the sweep

temporarily. Another press to the [F2] key will resume

the sweep.

During hold, the [F2] key is displayed as .

4.10.3 Sweep Auxiliary Outputs

While the signal generator performs sweep, it outputs signals that are synchronized to the sweep through the four

connectors located on the rear panel, as follows:

(1) X Out

Outputs sawtooth waves that are at 0 V at the sweep start point, and at +10 V at the sweep end point.

(2) Z Out

Outputs "H"-level TTL signals while it continues with sweep.

(3) Blanking Out

Outputs "H"-level TTL signals every sweep step, from the time when hardware setting is completed, till the next

step setting begins

(4) Marker Out

Outputs "H"-level TTL signals when the actual sweep matches the marker point which was set in the "Sweep

Parameter" menu.

Sweep

<Start-Stop>
0.1k

[Marker]

0.1k

1040M

Sel

Prmt

Rtn

Frequency