Panasonic AJ-SDd93 Operating Guide

– 12 –

9

1

6

5

1

Frame Ground

2

Transmit A

3

Receive B

4

Receive Common

5

6

Transmit Common

7

Transmit B

8

Receive A

9

Frame Ground

This enables signals to be input and output using the
IEEE 1394 digital interface. Use a 6-pin type of
connector.
Bus power is not supported.

Analog composite video signals are output from this
connector. 
Video signals with information superimposed on them
can be output.  To set the superimposing to ON or
OFF, use the SUPER switch 

on the front panel.

The playback signal from the PCM audio signals (CH1,
CH2, CH3, CH4) are output from these connectors.

This fan is used to cool down the VTR.
If, for any reason, the fan stops, “E-10” will appear on
the counter display.

Connect one end of the power cord supplied to this
socket and the other end to the power outlet.

This is connected to the signal ground terminal on the
component connected to this VTR in order to minimize
noise. It is not a safety ground.

Digital component audio/video signals complying with
the SMPTE 259M-C standard are input to and output
from these connectors.
Note:
The digital audio signals to be input must be
synchronized with the video input signals. Otherwise,
noise will be generated in the audio output signals.

Analog component video signals are supplied to these
connectors when the INPUT SELECT button on the
front panel is set to Y PB PR.  Analog composite video
signals are supplied using the VIDEO/Y connector 
when the button is set to CMPST.

Analog component video signals are output from these
connectors when the ANALOG VIDEO OUT selector
switch 

has been set to the Y PB PR side (bottom

position).  Analog composite video signals are output

from the 

and 

connectors when the switch has

been set to the VIDEO1/VIDEO2 side (top position).

Set this switch to the Y PB PR side (bottom position)
when the ANALOG VIDEO OUT connectors are used
to output component video signals; set it to the
VIDEO1/VIDEO2 side (top position) when they are
used to output composite video signals.

This is the input connector for the reference video 
signal. Input a signal with color burst.
Note: 
Since the video or audio output signal may be
disrupted if the reference video signal is not input, 
it is recommended that this connector be used by the
system which supplies the reference video signals.
Use a signal where SCH does not fluctuate for the
reference video signal.

This is the loop-through output connector of the REF
VIDEO IN connector 

. When a cable is not

connected to this connector, the REF VIDEO IN
connector 

is automatically terminated by the 75 

Ω

resistance.  When a cable is connected, the 75 

Ω

termination is released.

This connector is used for recording the external time
code onto the tape.

The playback time code is output from this connector
during playback. During recording, the time code
generated by the internal time code generator is output.

This enables the unit to be connected to the external
remote controller for operation from an external source.
Notes:
• Set the CONTROL switch 

to REMOTE.

• The specifications are based on the RS-422A

interface, and editing-related functions do not work.
In this case, use it as a player.

The analog audio signals are input from these
connectors.

The analog audio signals are output from these
connectors.