Panasonic AG-1070DC User Manual

Model # AG-1070DC
GENERAL
Power Source 12VDC (Operating Voltage: 10V-16V)
Power Consumption Approximately 14W
Operating Temperature +41˚F to 104˚F (+5˚C to +40˚C)
Operating Humidity 35% ~ 80%
Weight Approximately 11 lbs.
Dimensions (H x W x D) 4

3

⁄

4

" x 10

5

⁄

8

" x 13

9

⁄

16

"

SYSTEM
Television System EIA standard, NTSC color signal; 525 lines, 60 fields
Video Recording System 2 rotary heads, helical scanning system (VHS mode)
Video Head System 4 rotary heads
Modulation System Luminance; FM azimuth recording chrominance; 

Converted subcarrier phase shift recording

Audio Track 1 track
TAPE TRANSPORT
Tape Format VHS tape
Tape Speed 2-hour mode: 1

5

⁄

16

ips (33.35mm/s), 6-hour mode: 

7

⁄

16

ips (11.12mm/s)

Recording Time (w/NV-T120) 2-6 hours (VHS mode);

12-24 hours (linear slow mode)

FF/Rewind Time Approximately 3 min. w/NV-T120
VIDEO
Video In (BNC) 1.0V p-p, 75 ohms, unbalanced
Video Out (BNC) 1.0V p-p, 75 ohms, unbalanced
Horizontal Resolution VHS (2-hour mode): 43dB (color), 45dB (monochrome)
AUDIO
Audio In (Phono) -10dBV, 47K ohms, unbalanced
Mic In (M3) -60dBV, 600 ohms, unbalanced
Audio Out (Phono) -8dBV, 1K ohm, unbalanced
Audio Frequency Response 50Hz ~ 10kHz (2-hour mode)
CONNECTORS
Terminal Input Alarm, alarm reset, summer time
Terminal Output Tape end, warning
Camera Switching Signal 12V/0V, pulse width: 16.67ms
Remote Control For AG-A11 (option)

Weight and dimensions shown are approximate. 
Specifications subject to change without notice.
This product may be subject to export control regulations.

Warning: Unauthorized recording of copyrighted television programs, films,
videotapes and other materials may infringe upon the right of copyright owners
and be contrary to copyright laws.

(phono jacks)

When the image on the TV monitor runs
vertically during still-picture playback,
adjust these controls by turning them with
a small screwdriver.

Video input/output connectors (BNC);
connect the input connector to the video
camera, etc. and the output connector to
the TV monitor, etc.

Camera switching output connector;
connect it to the sequential switcher.

Install the battery in this area.

Alarm recording input connector; connect it
to the external sensor.

Input connector for releasing alarm
recording; +4 to +12VDC voltage is required.

This is used to switch between the present
time and summer time. 

When the cassette tape comes to its end
during recording, the alarm device installed
externally is activated.

When trouble has occurred in the unit, the
alarm device installed externally is
activated.

When being powered by the car battery,
wire the +12V power line using a 5A fuse.