Pelco C554M (2/98) User Manual

Pelco Manual C544M (2/98)

7

To install the Pelco Infrared VCR Controller, proceed as follows:

1.

Set the baud.

2.

Set the start address.

3.

Connect the CM9760-IRC to the CM9760-CC1 host.

4.

Connect additional IRC units in daisy-chain fashion.

5.

Connect VCRs to the Video Matrix Bay (CM9760-MXB).

6.

Connect the IR control cables to the VCRs.

Each step listed above is detailed below:

The communication card (refer to Figure 4) has a bank of eight DIP switches used to
do the following:

1.

Set the operating baud of the unit

2.

Set the start address

In Figure 5, DIP switch number 2 is ON.

Figure 4.  Communication Card

Figure 5.  DIP Switches