Sony HDW-D1800 User Manual

2

FOR USA  ONLY.
If used in USA, use the UL LISTED power 
cord specified below.
DO NOT USE ANY OTHER POWER 
CORD.
Plug Cap

Parallel blade with ground pin
(NEMA 5-15P Configuration)

Cord

Type SJT, three 16 or 18 AWG 
wires

Length

Minimum 1.5m (4 ft .11in.), 
Less than 2.5 m (8 ft .3 in.)

Rating

Minimum 10A, 125V

Using this unit at a voltage other than 120V 
may require the use of a different line cord 
or attachment plug, or both.
To reduce the risk of fire or electric shock, 
refer servicing to qualified service 
personnel.

1. Use the approved Power Cord (3-core mains lead) / 

Appliance Connector / Plug with earthing-contacts that 
conforms to the safety regulations of each country if 
applicable.

2. Use the Power Cord (3-core mains lead) / Appliance 

Connector / Plug conforming to the proper ratings 
(Voltage, Ampere).

If you have questions on the use of the above Power Cord 
/ Appliance Connector / Plug, please consult a qualified 
service personnel.

CAUTION
These servicing instructions are for use by qualified 
personnel only. To reduce the risk of electric shock, do not 
perform any servicing other than that contained in the 
Operating Instructions unless you are qualified to do so. 
Refer all servicing to qualified service personnel.

CAUTION
The apparatus shall not be exposed to dripping or 
splashing and no objects filled with liquid, such as vases, 
shall be placed on the apparatus.

CAUTION
The unit is not disconnected from the AC power source 
(mains) as long as it is connected to the wall outlet, even if 
the unit itself has been turned off.

For the customers in the U.S.A.
This equipment has been tested and found to comply with 
the limits for a Class A digital device, pursuant to Part 15 
of the FCC Rules. These limits are designed to provide 
reasonable protection against harmful interference when 
the equipment is operated in a commercial environment. 
This equipment generates, uses, and can radiate radio 
frequency energy and, if not installed and used in 
accordance with the instruction manual, may cause 
harmful interference to radio communications. Operation 
of this equipment in a residential area is likely to cause 
harmful interference in which case the user will be 
required to correct the interference at his own expense.

You are cautioned that any changes or modifications not 
expressly approved in this manual could void your 
authority to operate this equipment.

All interface cables used to connect peripherals must be 
shielded in order to comply with the limits for a digital 
device pursuant to Subpart B of Part 15 of FCC Rules.

For customers in Canada
This Class A digital apparatus complies with Canadian 
ICES-003.

For the customers in Europe
This product with the CE marking complies with both the 
EMC Directive (89/336/EEC) and the Low Voltage 
Directive (73/23/EEC) issued by the Commission of the 
European Community.
Compliance with these directives implies conformity to 
the following European standards:
• EN60065:  Product Safety
• EN55103-1:  Electromagnetic Interference (Emission)
• EN55103-2:  Electromagnetic Susceptibility (Immunity)
This product is intended for use in the following 
Electromagnetic Environment(s):

This symbol is intended to alert the user to 
the presence of uninsulated “dangerous 
voltage” within the product’s enclosure 
that may be of sufficient magnitude to 
constitute a risk of electric shock to 
persons.
This symbol is intended to alert the user to 
the presence of important operating and 
maintenance (servicing) instructions in 
the literature accompanying the 
appliance.