Sony DSR-2000A User Manual

Chapter 5

ClipLink Operation

98

Chapter 5

ClipLink Operation

You can rewrite the reel number, Mark IN/OUT points
and OK/NG status included in the ClipLink log data.

To change the reel number of the data item selected on
the ClipLink log data list, proceed as follows.

Using the search dial, move the selection mark
(asterisk) to the desired data item on the ClipLink
log data list.

Hold down the STOP button and press the SET
button.

The following setting screen appears.

Turn the search dial to select the digit to change.

Rotating the search dial clockwise moves the
current digit position to the right, and
counterclockwise moves it to the left.

Hold down the SEARCH button and turn the
search dial to change the digit indicated by an
arrow (

µ).

Repeat steps 3 and 4 until the settings for all digits
are complete.

When all digits have been set, hold down the
ENTRY/SHIFT button and press the MARK/+
button.

The reel number changes.

Hold down the STOP button and press the SET
button.

This returns to the original ClipLink log data list.

If you carry out step 7 skipping step 6, the original
ClipLink log data list appears again on the monitor
and, in this case, the reel number is not rewritten.

To change Mark IN/OUT points selected on the
ClipLink log data list, perform the following
procedure.

When Mark IN/OUT points are rewritten to the
cassette memory, the frame digits of the address data
are processed as follows.

For Mark IN point: Any frame-digits value is

counted as 1 second.

For Mark OUT point: Any frame-digits value is

ignored.

(003/196)

*REEL NO     (XXXXXXXX)

REEL NO    (YYYYYYYY)

CLIPLINK LOG DATA LIST