Tektronix WFM 601M User Manual

Jitter Measurement Commands

WFM 601A, WFM 601E & WFM 601M User Manual

The commands in this section allow you to change parameters for the Jitter
measurement display.

Selects the high-pass filter frequency for the Jitter measurement display.
This setting corresponds to the Jitter HPF selection in the Config Jitter menu.

JITter:HPFILter  <J10HZ |  J1000HZ | J10KHZ  | J100KHZ>
JITter[:HPFILter]?

 <J10HZ |  J1000HZ | J10KHZ  | J100KHZ>

jit:hpfilter j1000hz
jit:hpfil j10khz

jit?
:JITTER:HPFILTER J10KHZ;UNITS UI;ALIGNMENT 0.11 UI;TIMING 0.10
UI

Selects the units for the readout of jitter magnitude.

JITter:UNITS  <SEC  | UI | OFF>
JITter[:UNITS]?

 <SEC  | UI | OFF>

jit:units OFF

jit:units?
:JITTER:UNITS OFF