Hitachi VT-M290A User Manual

CHANNEL MEMORY PROGRAMMING (Without a Cable Box)  pg.  16. 

21 

 

  Set your TV to the Video Mode using 

VCR/TV button of your TV.  To set your TV to the TV mode, press VCR/TV button of 
your TV again. 
Connection Without AV Cord (Refer to page 12, 13, 15): 

Set the TV channel to the 

same video output channel located on the back of the VCR.  (CH 3 or 4)  Then, set your 
VCR to the VCR mode using VCR/TV button of your VCR. 

Channel memory programming is NOT needed when connected to a CABLE BOX.  You 
can program the tuner to scan only the channels you receive in your area.  See page 33 
for channel designations. 

  Follow the steps below, once.  Repeat it only if there is a power failure or the VCR is 

unplugged for more than 30 seconds.  In these cases, since the programmed channels are 
erased, the VCR will prompt you with "--:--" when you turn it on. 

  You must follow the steps below before attempting to play or record a video tape.  If you 

want to play ore record a video tap BEFORE programming the tuner, you must first press 
POWER button to turn off the VCR.  Then, press POWER button again to turn it back on.  
To program the tuner again, see "To preset channel memory again" on this page. 

Plug the VCR power cord into a standard AC outlet.  The "--:--" flashes.