Vidikron VP-5000VHDA User Manual

To reduce cable clutter, use the cable clamps provided with the PlasmaView VHD to bundle 
the video, audio and control cables at the back of the display. Install the clamps as shown in 
Figure 3-14. 

1

3

2

1

2

Pass the cable fixing
band through the clip
as shown.

To secure cables connected to the panel, wrap the cable tie around them. 
Then, pass the pointed end through the locking block as shown. Ensure that there is
sufficient slack in the cables to minimize stress, especially in the power cord. 

Pull

Pull

Push the catch

 Note: The power plug provided with your panel may differ from 
           the one shown here.

1

 Connect the AC cord plug to 

the panel.

2

 Attach the left clamp.

3

 Attach the right clamp.

Push until the hook clicks.

Squeeze the tabs together
and pull out.

 Attach the clamp.

Push until the
hook clicks.

Squeeze the 
tabs together
and pull out.

Press the two tabs together
and pull out. 

 Plug the AC cord into the power inlet on the
 panel until it clicks.

Note: Make sure that the AC cord is locked.

 Note: The power plug provided with your panel may differ from the one shown here.

3. Slide the clamp upward

 to secure the AC cord.

2. Insert the AC cord 

and close the clamp 
securely.

1. Open the clamp.

Clamp

AC cord

To loosen 
the clamp:

4. Insert the end of the 

clamp band into the 
small hole on the lower 

right of 
the back 
cover.