Timex W-116 User Manual

1. Press MODE until “CHR” appears.

2. Press START/STOP to start chrono.

3. Press START/STOP to stop. Press again to continue.

4. When chrono is stopped, press SPLIT/RESET to reset chrono to zero.

While the chrono is running, you may freeze the display, to see your time at a particular point.
This is called “taking a split.” To take a split, press SPLIT/RESET while the chrono is running.
“SPLIT” appears and the display will freeze for ten seconds before showing the running chrono
again. You may skip the ten-second freeze by pressing MODE.

If you exit Chrono mode with the chrono running, it will continue to run. In the Time display,
“CHR” will flash.

Press INDIGLO (SPLIT/RESET) when time of day or alarm time is displayed (but not while setting)
to activate night-light. Patented (U.S. pat. 4,527,096 and 4,775,964) electroluminescent technol-
ogy used in INDIGLO® night-light illuminates entire watch face at night and in low-light condi-
tions. Release INDIGLO to turn light off.

If your watch is water-resistant, meter marking or (

) is indicated.

Water-Resistance Depth

p.s.i.a.* Water Pressure Below Surface

*pounds per square inch absolute

1. Watch is water-resistant only as long as lens, push buttons and case remain intact.
2. Watch is not a diver watch and should not be used for diving.
3. Rinse watch with fresh water after exposure to salt water.

Timex strongly recommends that a retailer or jeweler replace battery. If applicable, push
reset button when replacing battery. Battery type is indicated on caseback. Battery life esti-
mates are based on certain assumptions regarding usage; battery life may vary depending on
actual usage.