Invacare X-Terminator BB User Manual

SECTION 4—BACK

Removing/Installing Foldover Back Upholstery

WARNING

The position of the footrest, seat angle, back angle, seating system/upholstery,

caster size and position, rear wheel size and position, use of anti-tippers, as well as

the user condition directly relate to the stability of the wheelchair. Any change to

one or any combination of the ten may cause the wheelchair to decrease in stability.

EXTREME care MUST be taken when changing the stability of the wheelchair. Refer

NOTE: For this procedure, refer to FIGURE 4.3.

Removing Foldover Back Upholstery

1. Unfasten the two fastening flaps that secure the bottom of the existing back upholstery

to the back canes.

2. Unfold the top of the back upholstery.

3. Lift up on the existing back upholstery and remove from the wheelchair.

Installing Foldover Back Upholstery

1. Install the new back upholstery onto

the back canes.

2. Wrap the end of a fastening flap around

the back cane.

3. Insert the end of the fastening flap

through the loop.

4. Wrap the fastening flap around the

back cane again and press firmly to
secure.

5. Fold the top of the back upholstery

down over the back canes towards the
front of the wheelchair.

6. Press firmly to secure the fastening

strips.

FIGURE 4.3 Removing/Installing Foldover

Fastening

Flap

Back Upholstery

Fold

Fastening

Flap

Back

Canes

Fastening

Strips

Loops

Front of

Wheelchair