Invacare X-Terminator BB User Manual

SECTION 5—WHEELS

Adjusting Quick-Release Axles

NOTE: For this procedure, refer to FIGURE 5.2.

1. Remove rear wheel and quick‐release axle from the wheelchair. Refer to

2. Depress detent pin in the quick‐release axle and slide axle through the wheel hub.

3. Release detent pin ensuring that the locking pins are fully released.

4. Increase or decrease end play by adjusting the locknut on the end of the quick‐release

axle.

5. Reinstall rear wheel onto the wheelchair. Refer to Removing/Installing Rear Wheels

FIGURE 5.2 Adjusting Quick-Release Axles

Replacing Quad-Release Axles

NOTE: For this procedure, refer to FIGURE 5.3.

1. Remove rear wheel and the existing quick‐release axle from the wheelchair. Refer to

2. Remove existing quick‐release axle from rear wheel.

3. Insert new quad‐release axle through

rear wheel hub.

4. Slide locking collar onto quad‐release

axle until it is snug against rear wheel
and tighten securely with allen screw.

5. Reinstall rear wheel and the

6. Flip the handle of the quad‐release axle

down to release the detent pin ensuring
that the locking pins are fully released.

FIGURE 5.3 Replacing Quad-Release Axles

Locking Pins

Quick-Release Axle

Detent Pin

Locknut

Adjustable Axle Position

Camber Bar

Wheel Hub

NOTE: End of Quick Release
axle is shown for reference
only. It is not visible when
inserted into camber bar.

NOTE: End of
Quick Release
axle is shown for
reference only. It
is not visible
when inserted
into camber bar.

Quick-Release

Axle

Rear Wheel

Hub

Locking

Collar

Allen Screw