Invacare X-Terminator BB User Manual

SECTION 5—WHEELS

Everyday and Sport Series Wheelchairs

FIGURE 5.10 Adjusting Toe In/Toe Out - A4 Camber System - Co urse Adjustment

NOTE: DO NOT tighten the phillips screw on the other adjustment ring at this time.

NOTE: Repeat STEPS 1‐7 of this procedure for the other adjustment ring after repositioning the
camber insert. Refer to Adjusting Rear Wheel Camber on page 41.

NOTE: When positioning the other adjustment ring, rotate the ring until the stop is at the bottom
of the slot in the camber clamp. The right and left stops MUST be positioned opposite to each other
or Fine Adjustment on page 45 will not work correctly.

NOTE: When the left adjustment ring is adjusted to a camber, the right adjustment ring will not
touch the camber clamp and when the right adjustment ring is adjusted to the other camber the left
adjustment ring will not touch the camber clamp.

Fine Adjustment
NOTE: For this procedure, refer to FIGURE 5.11.

NOTE: This adjustment is required anytime the camber insert is repositioned.

1. Open the camber clamp. Refer to Opening/Closing Camber Clamps on page 39.

2. Slowly rotate the axle tube until the stop on the opposite adjustment ring is positioned

at the opposite end of the camber clamp.

WARNING

QUICK RELEASE LEVERS - Make sure the quick release levers are pointing

towards the rear of the wheelchair and are in the closed position before using the

wheelchair, otherwise personal injury or damage to the wheelchair may occur.

Stop - Not touching

camber clamp

Adjustment Ring

Camber Clamp

Adjustment Ring

Camber Clamp

Stop - In position for one

camber, touching camber clamp

Stop - In position for one

camber, touching camber clamp

Adjustment Ring

Stop - Not touching

camber clamp

Adjustment Ring