Invacare X-Terminator BB User Manual

SECTION 8—SUSPENSION

FIGURE 8.1 Replacing Rear Elastomers

Replacing Front Elastomers

CAUTION

DO NOT use excessive force when removing/installing the threaded sleeve

from/onto the fork. Damage to the threaded sleeve may occur.

NOTE: For this procedure, refer to FIGURE 8.2.

1. Using two allen wrenches, turn in opposite directions and remove one mounting

screw from fork.

NOTE: One mounting screw will not turn.

2. Remove the threaded sleeve and mounting screw assembly from the fork. DO NOT

use excessive force.

3. Remove the existing elastomer from the fork.

4. Install NEW elastomer determined in STEP 1 into fork.

NOTE: Make sure the elastomer sits in the two recessed areas on the fork.

5. Align the mounting holes in the upper and lower portion of the fork.

6. Reinstall threaded sleeve and mounting screw assembly. DO NOT use excessive force.

Outside of

Wheelchair Frame

Inside of Wheelchair Frame

Suspension Base

Mounting

Holes

Axle Bracket

Inner Allen

Screw

Recess

Elstaomer

Pivot Pin

Recess

Outer Allen

Screw