Invacare 9000 STANDARD WEIGHT User Manual

8   REAR WHEELS

1.

Remove the rear wheel from the wheelchair. For non-recliner models, 

2.

Remove the mounting screws that secure the handrim to rear wheel.

3.

Remove the existing handrim.

4.

Install the new handrim by reversing the preceding steps.

5.

Reinstall rear wheel to the wheelchair. Refer to Removing/Installing 

6.

If the detent balls of the quick-release axles (if applicable) are not 

protruding past the inside of the axle bushing or there is too much 

movement of the rear wheel assembly in a back and forth position, 

7.

Repeat STEPS 1-6 for the opposite rear wheel if necessary.

FIGURE 4   Replacing Rear Wheel Handrim



If the wheelchair is equipped with permanent axles, this procedure must be performed by a qualified technician.



Make sure detent pin and detent balls of the 
quick-release axles are fully released before operating 
the wheelchair.

Mounting Screw

Rear Wheel

Handrim



Replacement of rear wheel tire or tube MUST be performed by a qualified technician.



As with any vehicle, the wheels and tires should be checked periodically for cracks and wear, and should be replaced.