Invacare EX2 User Manual
SECTION 11—OPTIONS
38
SECTION 11—OPTIONS
WARNING
After any adjustments, repair or service and before use, make sure all attaching hardware is
tightened securely. Otherwise injury or damage may occur.
Installing Amputee Bracket
NOTE: For this procedure, refer to FIGURE 11.1 on page 38.
1.
Refer to the following chart or FIGURE 11.1 to determine the mounting position of the amputee bracket:
*NOTE: ʺAʺ and ʺBʺ are stamped on the sides of the amputee bracket.
2.
Install the amputee bracket on the wheelchair frame to the position determined in STEP 1.
NOTE: Make sure the axle spacer is pointing towards the outside of the wheelchair.
3.
Install the two hex screws and locknuts that secure the amputee bracket to the wheelchair.
4.
Install the rear wheels onto the wheelchair. Refer to Removing/Installing Rear Wheels on page 30.
FIGURE 11.1 Installing Amputee Bracket
SEAT-TO-FLOOR *BRACKET AXLE SPACER POSITION
(ON BRACKET)
SIDE OF
WHEELCHAIR
AXLE MOUNTING
POSITION
(ON WHEELCHAIR)
ADULT
ADULT
ADULT
HEMI
HEMI
HEMI
A
B
B
B
A
DOWN
DOWN
DOWN
UP
UP
UP
RIGHT
LEFT
RIGHT
LEFT
TOP
TOP
TOP
BOTTOM
BOTTOM
BOTTOM
Bracket “A”
Bracket “B”
Locknuts
Hemi Right
Hemi Left
Rear View of
Amputee Bracket
Right
Left
Adult Right
Axle Spacer Toward Outside
of Wheelchair
Adult Left
Axle Spacer Toward Outside
of Wheelchair
Hex Screws