Conair CS26TRCS User Manual

Page of 2
IMPORTANT SAFETY 
INSTRUCTIONS
When using electrical appliances, especially 
when children are present, basic safety 
precautions should always be followed, 
including the following:
READ ALL INSTRUCTIONS
BEFORE USING
KEEP AWAY FROM WATER
DANGER
 —
 Any appliance is elec-
trically live even when the switch is off. To 
reduce the risk of death by electric shock:
1. Always unplug appliance immediately after using.
2. Do not use while bathing or in a shower.
3. Do not place or store appliance where it 
can fall or be pulled into a tub or sink.
4. Do not place in, or drop into water or other 
liquid.
5. If an appliance falls into water, unplug it 
immediately. 
Do not reach into the water.
WARNING
 —
 To reduce the risk 
of burns, electrocution, fire, or injury to 
persons:
1. This appliance should never be left unat-
tended when plugged in.
2. This appliance should not be used by, on, 
or near children or individuals with certain 
disabilities. 
3. Use this appliance only for its intended 
use as described in this manual. Do not 
use attachments not recommended by the 
manufacturer. 
4. Do not use an extension cord to operate 
appliance.
5. Never operate this appliance if it has a 
damaged cord or plug, if it is not working 
properly, if it has been dropped or damaged, or 
dropped into water. Return the appliance to 
an authorized service center for examination 
and repair.
6. Keep the cord away from heated surfaces.
7. Do not pull, twist, or wrap line cord around 
appliance, even during storage.
8. Never place the appliance on a soft surface, 
such as a bed or couch, where the air openings 
may be blocked.
9. Never use while sleeping.
10. Never drop or insert any object into any 
opening or hose.
11. Do not use outdoors or operate where 
aerosol (spray) products are being used or 
where oxygen is being administered.
12. This straightener is hot when in use. Do not 
let eyes or bare skin touch heated surfaces.
13. Do not place the heated straightener 
direct ly on any surface or on the appliance 
power cord while it is hot or plugged in.
14. Before plugging in read the information 
about dual voltage contained in the instruc-
tion section of this manual.
15. Do not attempt to touch the housing 
of your appliance near the straightening 
plates as it is hot when in use.
SAVE THESE 
INSTRUCTIONS
OPERATING 
INSTRUCTIONS
This straightening iron appliance is intended 
for household use. This unit is designed 
to operate at 120/240 volts AC. Use on 
Alternating Current (50/60 hertz) only. 
This appliance has a polarized plug (one 
blade is wider than the other). As a safety 
feature, this plug will fit in a polarized outlet 
only one way. If the plug does not fit fully 
in the outlet, reverse the plug. If it still does 
not fit, contact a qualified electrician. Do not 
attempt to defeat this safety feature.
DUAL VOLTAGE
This straightening iron will automatically 
adjust to the proper voltage. Use an adapter 
plug with correct configuration, prior to use 
in outlet.
DRYING SYSTEM WITH UNIQUE  
DRY 
,
N STRAIGHT
™ 
WET 
• 
DRY DESIGN
This Wet 
 Dry Ceramic Straightener features 
our exclusive vent and channel design, allow-
ing for use on dry or damp hair. When used on 
damp hair, excess water is forced into chan-
nels where it can escape as steam. The steam 
evaporates through the vents in the housing, 
while the hair’s natural moisture is sealed into 
the cuticle. 
CAUTION: Steam evaporating through the 
vents may be hot. During use, avoid touching 
or blocking the vents and direct drying vents 
away from your scalp and face.
STRAIGHTENING BASICS
1. Plug the straightening iron cord into any 
household outlet (120/240V). Press on but-
ton (the red light will go on to indicate that 
the straightener is plugged in). The iron will 
heat up very quickly. The green indicator 
light will indicate that the unit is heating 
up. To turn off, press off button (green light 
will go off. Red light will remain on as a 
safety precaution to indicate the iron is still 
plugged in). Never leave your straightening 
iron on and unattended. 
WARNING: The straightening iron's ceram-
ic-coated plates will get very hot within a 
few seconds and should not be placed in 
contact with the skin after the straighten-
ing iron has been turned on. 
Start with a hair section that is 2" wide and 
no more than 1/2" thick. Open the iron and 
place a hair section between the two hot 
plates, close to the scalp. Trap hair between 
the plates by firmly squeezing the handles 
together. While maintaining the tension, slow-
ly pull the unit down along the hair section 
toward the end of hair. At the end of hair sec-
tion, release the pressure on the handle and 
allow the hair section to slide out. Repeat 
process on additional sections of hair until 
you achieve the hair style you desire. It may 
be necessary to repeat process on certain 
areas, depending on the texture of your hair 
or how damp it is.
Some experience is necessary when learning 
to use this straightening iron. After using iron 
several times, you will learn the ideal way to 
straighten and style your hair easily. 
NOTE: Please refer to the temperature  
setting guide for heat settings, especially if 
using your iron on wet hair.
STYLING WITH THE NEW EASY-GLIDE 
CERAMIC-COATED PLATES
The plates of your new straightening iron 
have an easy-glide ceramic-coated surface, 
the newest technology. 
This means it’s not only simpler to clean off 
styling product residue after each use, but 
you’ll also find that hair glides easily over 
the surface of the plates as you’re straight-
ening. The ceramic-coated surface also 
helps smooth down flyaways and frizzies. 
As you smooth each strand, heat is evenly 
distributed so that the style you create has 
a salon-perfect, silky smooth, shining fin-
ish. Hair slips right off the plates after it’s 
straightened.
The ceramic technology is a pleasure to 
work with because it makes styling your hair 
easier and the results more professional.
USING INSTANT HEAT,  
THE 25 WET
 DRY VARIABLE  
TEMPERATURE SETTINGS &  
UNIFORM HEAT RECOVERY SYSTEM 
This straightening iron features Conair’s 
Instant Heat technology. Within this Instant 
Heat technology there are 25 variable  
wet 
 dry temperature settings for every type 
of hair, from the finest to the curliest and most 
resistant. Use the low settings for wet/damp 
hair and as your hair dries turn to the medium 
settings. Once hair is completely dry, use 
the medium to high settings to complete the 
straightening process.
Temperature Setting Guide 
And that’s not all. Conair’s professional salon 
standards of engineering provide you with 
a Uniform Heat Recovery System that main-
tains the straightening iron at a  
constant temperature. 
There is a constant surge of power to 
ensure that heat is continuously delivered 
for optimal styling results, unlike other 
units which lose heat during use. This pro-
vides consistent styling power so that every 
strand of your hair is set with the same 
level of heat and comes out the same way 
for a perfect finish.
TEMP. CONTROL 
HAIR TYPE
Low/Wet 1-8 
Delicate, thin, easy-to-straighten hair
Medium/Damp 9-14  Average to thick or treated hair
Med/High/Dry 15-20  Thick or wavy hair
High/Dry 21-25 
Hard-to-straighten hair. 
CS26TRCS IB-9-292.indd   1
7/21/09   5:39:20 PM