Sony Ericsson P910a User Manual

• When the battery needs to be charged, a beep is heard. The 

indicator light (on the top of your P910a) flashes red and a 
battery low message appears on the screen. 

• The battery can be charged whenever you want. The P910a 

performance is not affected. However, using your P910a 
while charging increases the charging time.

The P910a can be charged either when it is switched on or off.

1. Make sure the battery is inserted in your P910a and the cover 

is closed.

2. Connect the charger to 

the P910a at the base of 
the phone by the flash 
symbol. The charger 
plug flash symbol must 
face upwards.

3. Connect the charger to the mains.

Charging is indicated by the battery icon 

 on the screen 

pulsing continuously, and the indicator at the top of the 
P910a showing a steady red light (or green, if the P910a is 
switched on).

See also ‘Battery Use and Care’ on page 184.

4. Wait approximately 4 hours or 

until the battery meter on the 
screen is full and the indicator 
on the top of the P910a shows 
a steady green light.

5. Remove the charger by tilting 

the plug upwards.

Tip You can also use other battery chargers that have been 
supplied with other Sony Ericsson mobile phones using the same 
connector plug, for example, T300 or P900.

Note When the battery is completely discharged, or new, it may 
take up to 30 minutes before the battery icon 

Your P910a is a highly sophisticated electronic device. To get 
the most out of it, please make sure that you follow this advice:

• Keep the P910a in its protective bag when not using it. 
• Use a commercial glass screen cleaner sprayed on a cloth, 

when you clean the screen.

• Use only the stylus provided to tap the screen.