Sony Ericsson LBI-38965 User Manual

For each site defined in the CAL.DAT file, configure the associated port on the terminal server as follows:

Server>> change port  

Server>> change port  

Server>> change port  

Server>> change port  

Server>> change service PORT_<

Server>> change port  

Server>> change port  

TCP port_no is the value defined in CAL.DAT for a particular site.

Assume that the file CAL.DAT has the following two site entries:  System Manger site 2 is connected to port 3 on the

distribution panel, and System Manager site 10 is connected to port 6 on the distribution panel.

SITE.02.PASSWD

SITE02

SITE.02.IP

147.117.37.10

#Terminal server IP address

SITE.02.PORT

5002 

#TCP port_no used for site 2

SITE.10.PASSWD

SITE10

SITE.10.IP

147.117.37.10

SITE.10.PORT

5010

#TCP port_no used for site 10

Inserting the information below would configure the terminal server for the values shown above.

Server>> change port 3 access remote
Server>> change port 3 type softcopy
Server>> change port 3 autobaud disabled   
Server>> change port 3 speed 19200
Server>> change service PORT_3  5002 port 3 telnet disabled
Server>> change port 3 queuing disabled
Server>> change port 3 flow control disabled

Server>> change port 6 access remote
Server>> change port 6 type softcopy
Server>> change port 6 autobaud disabled
Server>> change port 6 speed 19200
Server>> change service PORT_6  5010 port 6 telnet disabled
Server>> change port 6 queuing disabled
Server>> change port 6 flow control disabled

After completing the configuration, reconnect the Ethernet LAN connection to the terminal server.  If a second terminal

server is installed, repeat the procedure above.