Panasonic KX-PRW110FX User Manual
Display message
Cause/solution
You must first
subscribe
to Caller ID.
subscribe
to Caller ID.
R You must subscribe to a Caller ID service. Once you receive
caller information after subscribing to a Caller ID service, this
message will not be displayed.
message will not be displayed.
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit’s
AC adaptor and turn off the handset, then reconnect the base unit’s AC adaptor and turn on the
handset.
AC adaptor and turn off the handset, then reconnect the base unit’s AC adaptor and turn on the
handset.
General use
Problem
Cause/solution
The handset does not turn
on even after installing
charged batteries.
on even after installing
charged batteries.
R Place the handset on the base unit or charger to turn on the
handset.
The unit does not work.
R Make sure the batteries are installed correctly (page 10).
R Fully charge the batteries (page 10).
R Check the connections (page 10).
R Unplug the base unit’s AC adaptor to reset the unit and turn off
R Fully charge the batteries (page 10).
R Check the connections (page 10).
R Unplug the base unit’s AC adaptor to reset the unit and turn off
the handset. Reconnect the adaptor, turn on the handset and
try again.
try again.
R The handset has not been registered to the base unit. Register
the handset (page 33).
The handset display is
blank or dark.
blank or dark.
R The handset is in screen saver mode (page 13). Activate the
handset display again by:
– pressing M
– pressing M
N when on a call.
– pressing M
N at all other times.
R “LCD in charging” is set to “Off” while on charge.
Change the setting (page 24).
R The handset is not turned on. Turn the power on (page 13).
I cannot hear a dial tone.
R Make sure that you are using the supplied telephone line cord.
Your old telephone line cord may have a different wiring
configuration.
configuration.
R The base unit’s AC adaptor or telephone line cord is not
connected. Check the connections.
R Disconnect the base unit from the telephone line and connect
the line to a known working telephone. If the working
telephone operates properly, contact our service personnel to
have the unit repaired. If the working telephone does not
operate properly, contact your service provider/telephone
company.
telephone operates properly, contact our service personnel to
have the unit repaired. If the working telephone does not
operate properly, contact your service provider/telephone
company.
The handset display
begins operating
automatically.
begins operating
automatically.
R Demonstration mode is activated. Please connect the
telephone line cord to the telephone line jack (page 10).
46
Useful Information
PRW110FX(en)_0724_ver012.pdf 46
2013/07/24 13:40:27