Panasonic MN101C77C User Manual

Chapter 2 CPU Basics

II - 6

Overview

2-1-4

Pipeline Process

Pipeline process means that reading and decoding are executed at the same time on different instruc-

tions, then instructions are executed without stopping. Pipeline process makes instruction execution

continual and speedy. This process is executed with instruction queue and instruction decoder.

Instruction queue is buffer that fetches the second instruction in advance. That is controlled to fetch the

next instruction when instruction queue is empty at each cycle on execution. At the last cycle of instruc-

tion execution, the first word (operation code) of executed instruction is stored to instruction register. At

that time, the next operand or operation code is fetched to instruction queue, so that the next instruction

can be executed immediately, even if register direct (da) or immediate (imm) is needed at the first cycle

of the next instruction execution. But on some other instruction such as branch instruction, instruction

queue becomes empty on the time that the next operation code to be executed is stored to instruction

immediate data (imm) are needed, instruction queue keeps waiting for a cycle.

Instruction queue is controlled automatically by hardware so that there is no need to be controlled by

software. But when instruction execution time is estimated, operation of instruction queue should be into

consideration. Instruction decoder generates control signal at each cycle of instruction execution by

micro program control. Instruction decoder uses pipeline process to decode instruction queue at one

cycle before control signal is needed.

2-1-5

Registers for Address

Registers for address include program counter (PC), address registers (A0, A1), and stack pointer (SP).

Program Counter (PC)

This register gives the address of the currently executing instruction. It is 19 bits wide to provide access

to a 256 KB address space in half byte(4-bit increments). The LSB of the program counter is used to

indicate half byte instruction. The program counter after reset is stored from the value of vector table at

the address of 4000.

Program
counter