Panasonic 700 User Guide

Chapter 2. Attendant Features

Section 700 - Operation  

2-4

DBS Manual - Revised April 2000

DBS-2.3/9.2-700

4.  Enter the Speed Dial code (00-89 or 000-199).

“Enter SSD XX” appears on the display (where “XX” is the System 
Speed Dial code).

5.  To select pooled trunk access, press CONF followed by the last digit of 

the pooled trunk number (9, 1-6).

6.  Dial the telephone number to be stored. 

For each pause required, press REDIAL. (An R appears on the display 
when REDIAL is pressed . If the Speed Dial number is later displayed, a 
P appears.)

The number appears on the display. 

7. Press 

the 

HOLD key.

“SSD XX” (where “XX” is the Speed Dial code) and the stored telephone 
number appear on the display.

8.  Repeat steps 2 to 7 to store additional numbers.

• Storing a new number erases any previously stored data.

• To delete a System Speed Dial number, perform the programming steps, 

but do not enter a number before pressing HOLD.

• Names for System Speed Dialing can also be stored using a DSS console 

connected to the attendant phone.

(CPC-AII and CPC-B Version 2.0 or higher)

The Attendant Busy Override feature allows the attendant to break in on an 
Intercom Call or a CO Call that is already in progress.

Attendant Busy Override can break into any extension, even if the extension 
has “Busy Overridden” turned off. (The extension feature “Busy Override” 
cannot break into an extension that has “Busy Overridden” turned off.)

System programming determines whether the override is preceded by an alert 
tone. By default, Attendant Override does not sound an alert tone.